Thermal management is the most difficult, demanding and costly design part of new LED lamps. Failure to perform adequate thermal management will result in catastrophic consequences such as lighting failure or fire. Failure to perform effective thermal management can result in catastrophic consequences such as frequent replacement of failed LED lights or building fires. The use of intelligent LED light control to monitor the temperature of the LED light is a relatively simple thermal management method, and because the LED light can reduce the power when the temperature rises, the safety will be greatly improved.
NTC thermal management
The basic principle of the NTC circuit is to improve the safety of the LED lamp and reduce the design complexity by monitoring the temperature of the LED lamp. As the temperature increases, the controller reduces lumens and thereby keeps the LEDs within safe levels. In other words, when the temperature rises, the lumen is reduced, and conversely, when the temperature drops, the lumen is increased.
We can detect the temperature change of the LED lamp by detecting the voltage on the NTC. The detected voltage is directly related to the temperature of the NTC, and the resistance of the NTC decreases as the temperature of the NTC and its peripheral circuits increases. There are two basic ways to determine temperature using NTC.
Method 1: Use NTC in a voltage divider circuit that enforces a known voltage in the system, and then measure the voltage on the NTC node. When the NTC temperature rises, the resistance decreases. A decrease in resistance will result in a change in the divider ratio. The voltage at the NTC node also drops as the temperature increases.
Method 2, forcing the known current to pass through the NTC and measuring the voltage on the NTC. When the NTC temperature rises, the resistance decreases. According to Ohm's law, the reduction in resistance will change the voltage on the NTC node. If the resistance is reduced and the current remains the same, the voltage on the NTC node will also drop.
In terms of improving operation and improving safety, the two methods of monitoring the temperature of the LED lamp are simple and straightforward to implement. Figure 1 is a schematic diagram of two methods of using an LED as a source of temperature rise.
Two basic methods of determining temperature using NTC.
Is the temperature too high or is the LED fault?
Street Legal Electric Car,Street Legal Electric Vehicle,Fastest Street Legal Electric Car,Electric Utility Vehicle Street Legal
Jinan Huajiang environmental protection and energy saving Technology Co., Ltd , https://www.hjnewenergy.com